Preparation

Make sure final finish coat has been:

• stripped and removed (varnish, wax, urethane, paint)
• cleaned  and ready to receive the oil
• dust free

Apply the oil with either:

• a brush
• a lint free cotton rag. 

You do not need to use a sealer:

• The first coat is your sealer

Apply your first coat thick:

• feed the wood
• continue applying coats until the surface is thoroughly soaked
• start hand rubbing the oil into your wood
• wipe  off excess
• Let dry for 48 to 72 hours

The rags are combustible:

• spontaneous combustion is possible
• submerge the rags, in water.
• keep all materials out of the reach of children

Apply second coat: 

• remove any dried on dust that may have collected using 0000 fine steel wool
• remove any dust with a tack rag
• apply second coat
• Soak the wood again
• hand rub
• Let dry for 48 t0 72

Repeat Coats:

• Repeat as many times as you would like

remember rags are flammable

Clean-Up:

• Clean with either paint thinner or mineral spirits

Keep this product out of the reach of children

This product is flammable; keep the product and rags away from open flames and hot surfaces